Course Objective
This 5 days course is developed to give hand on practical experience and skills on PLCs Configuration, Programming and Maintenance. Application is opened to anyone desiring to become automation specialist.
Course Code: PLC006
Duration: 5 days; 8 hours per day
Course Fee: N160,000 ($305 USD)
Schedule: September/October:
27th to 2nd
November:
22nd to 27th
Course Content
Day1: Omron CX-Programmer with CQ1MH PLC
- CQM1H hardware
- Introduction to CX-Programmer software environment
- Create a project
- Configure hardware
- Communication setup
- Instructions and commands review
- Programming with ladder logic
Day2: Omron CX-Programmer with CQ1MH PLC
- Case study simulation of PLC
- Close loop programming
- Programming of temperature, flow, level and pressure control loop
- Upload from PLC
- Download to PLC
Day3 DirectLogic5 Software with Direct Logic 250 PLC
- PLC hardware
- Communication setup with PLC
- PLC Cycle scan
- Basic introduction to directlogix6 software features, instructions, monitoring the program
- DirectLogix6 advance programming
- Create new project
- Upload and download
Day4 DirectLogic5 Software with Direct Logic 250 PLC
- Develop, implement and program control loops for;
- Digital input and output
- Analog input and output
- Level control loop
- Motor control loop
- Pressure control
- Flow control loop
- Temperature control loop
- SIF control
Day5 DirectLogic5 Software with Direct Logic 250 PLC and Omron CX-Programmer with CQ1MH PLC
- Develop, implement and program control loops for;
- Digital input and output
- Analog input and output
- PID programming
- Wire sensors to PLC input channels
- Wire switches to PLC input channels
- Wire final control elements to PLC output channels
- Wire indicators to PLC output channels